Suppressor Concentricity

  • leadoff_suppressor_concentricity.jpg


Is your suppressor on straight? Unless your gunsmith checked at the time you got your barrel threaded... you might not know! In the video, you'll see just how far from straight some suppressors can be. I was at TS Customs shop getting a barrel threaded, and just for the heck of it, we threaded the suppressor on and checked it for concentricity after getting the threads cut. What we found was not confidence inspiring in regard to how tight of tolerances some suppressor manufacturers are keeping. Point in fact, one was so bad that we're certain there would have been a baffle strike if it were fired in that condition. In the video, we prove that it was the suppressor, not the thread job which was crooked. Be sure to watch through to the end and we'd love to hear your feedback.

Call Us Today To Order!    605-554-1911

Primal Rights, Inc
33 3rd St SE STE 101
Huron, SD 57350

© Copyright 2009-2016 Primal Rights Inc
ALL RIGHTS RESERVED

No part of this website may be reproduced, distributed, or transmitted in any form or by any means without the express prior written permission of Primal Rights, Inc